Not heating, moisture-loaded vent blockage — Same-day, fixed quote.
A dryer that spins cold or needs two cycles per load is the most common ticket we run out of the Washington Square Road base — and in Tigard's two-story homes and stacked townhome closets the backstory repeats: a long vent run packed with the sticky lint our damp air produces. So we fix the part that failed and measure the airflow that killed it, because a thermal fuse replaced into a clogged duct is a subscription, not a repair.
The parts casework splits by what's in your closet. Whirlpool, Maytag and Kenmore 110-series machines — thick on the ground in Metzger and Greenburg — blow the famous blower-housing thermal fuse, squeal through worn idler pulleys, and snap belts after a decade of heat. The Samsung and LG front-load dryers of Bull Mountain's newer builds break heating elements and throw heat-circuit codes instead. Gas units add the igniter test: a bright orange glow with no flame convicts the valve coils, one of the most satisfying cheap fixes in the trade.
Describe the sound when you call and we'll usually name the part before the van leaves the Square: an escalating squeal is the idler pulley, a steady thump is rollers or a hardened belt, a scrape is the felt seal or a coin in the gap, and silence with a freewheeling drum is a snapped belt tripping its safety switch. Noise-stage repairs are the affordable ones; waiting promotes them a tier.
Fuses, elements, belts, rollers and pulleys for the common platforms live on the van, so most 97223/97224 dryer calls finish the same visit — with an exit-vent airflow reading in hand, because that number is also the fire-safety story told straight.
We reach all of Tigard — Nike corridor, Cedar Hills, Bethany, Raleigh Hills — plus the wider west side, same-day.